Drill depth show with gyro sensor – Open Electronics


By on September 22, 2022

Most bench drills have a ruler to learn the drilling depth. The larger the accuracy at which the specified place may be learn, the larger the success of the job. On this venture we see another proposal: a show wherein we see the drilling depth because of a gyroscopic sensor and an 8-digit 7-segment show with Arduino Nano assist.

 

However how is the depth of drilling measured? There are a number of prospects for a size measurement. An ultrasonic measurement might work, a wire encoder and a rotary encoder are additionally choices, right here we see another resolution.

Most drills have a facet handwheel to regulate the depth which may be turned approx. 270 °. So not even a full flip, you’ll be able to then measure the angle with a gyro sensor. The cable connection can’t be twisted and just one cheap part is required (such because the MPU-6050).

Extra data

About Bianchi Gabriele





Source_link

Leave a Reply

Your email address will not be published.