Professionals & Cons of 3D Printing Publish Processing

Publish-processing can enhance a printed half’s aesthetics, however it will possibly additionally enhance the power and different properties. When you uncover the great thing about post-processing, you’ll by no means need to go away your 3D prints untouched once more. 

Virtually each 3D print requires some form of post-processing after it’s printed. There’s a whole lot of data and recommendation about post-processing 3D prints on the market, however right here completely different  strategies to contemplate


Completely different strategies methods to end 3d prints

Components manufactured with 3D printing applied sciences normally require a point of post-production remedy. This essential step of the 3D printing course of is called post-processing. 

In brief, post-processing in 3D printing refers to any course of or activity that must be carried out on a printed half, or any method used to additional improve the item.

Listed are 5 of the strategies we do right here at 3D2GO for sprucing abs plastic and different supplies:

Technique Professionals Cons
Help Elimination

Relying on what they’re made from, helps will be insoluble or soluble.

Eradicating insoluble helps is normally achieved by snapping them along with your fingers or reducing them with a pair of pliers.

However, soluble helps can merely be dissolved by soaking the half in both water or one other liquid, leaving little to no marking or residue.

• Comparatively straightforward to do

• Doesn’t require a lot gear

• Soluble helps present extra design flexibility

• Even when eliminated fastidiously, helps can go away marks

• Whereas typically structurally obligatory, helps don’t enhance the looks or properties of a component


Refers to connecting ABS components utilizing acetone.

Apply slightly little bit of acetone onto the half you’d prefer to “glue”.

• Stronger than different becoming a member of strategies

• Cheap

• Low skill-level required

• If an excessive amount of acetone is utilized, the whole half will be ruined

• The weld will not be as robust as the remainder of the half

• Solely ABS will be welded with acetone


Just like welding, that is typically used when one thing can’t be printed in a single piece because of the dimensional constraints of the printer.

• Works with widespread filaments (PLA, PETG)

• Cheap

• Not time-consuming

• Not as robust as welding; components are weak on the gluing level

• Will be messy

Priming & Portray

Priming is a post-processing method that’s used for getting ready a floor for portray. It merely means coating the half with both primer paint or primer spray

As soon as all the pieces is dry, you can begin portray.

• Enhances the look, including coloration, in addition to the texture of a component

• Offers a easy floor end

• Works on all FDM supplies

• Comparatively time-consuming

• Will be expensive because of the gear wanted

• Some talent is required to attain nice outcomes

Hydro Dipping

Often known as water switch printing or water switch imaging. A strategy of making use of printed graphic designs to strong objects utilizing particular water switch paper.

Hydro dipping is simply used for enhancing the aesthetics of the item and doesn’t change the texture or any dimensional properties.

• Dimensional accuracy is maintained

• Full design freedom

• Works on all supplies

• Paper transfers will be costly

• Just a few makes an attempt are wanted to get the texture for performing this method

• Not proof against scratches or different floor injury


The place can I am going for a3D print ending?

Publish-processing is turning into more and more an integral a part of the 3D printing course of. 

With particular post-processing machines being developed the method is turning into automated which makes it extra scalable than beforehand potential.

You may have the choice to make use of 3D2GO’s post-processing companies. Contact us right now!



Leave a Reply

Your email address will not be published.